Experimental Training Board has been designed specifically to study Differential Pulse Code Modulation & Demodulation. In the basic DPCM Modulator the base band analog signal is covered into 8 bit digital format using an ADC. The sampling rate is set at 2.5 Khz.

The DPCM Demodulator receives the serial data, converts it into 8 bit parallel format. The Digital to Analog converter transforms the 8 bit parallel data into analog level. Thus the output of DAC is a stepped approximation of input signal. A low pass filter is used to recover the analog signal.
Practical experience on this board carries great educative value for Science and Engineering Students.

Object:
To study Differential Pulse Code Modulation & Demodulation.

Features:
The board consists of the following built-in parts :
01. 5V D.C. at 100mA IC regulated power supply internally connected.
02. ± 12V D.C. at 100mA IC regulated power supply internally connected.
03. – 5V D.C. to 5V D.C. Variable D.C. output.
04. Audio Frequency Oscillator 10Hz to 100Hz for modulation.
05. DPCM Modulator (DPCM ENCODER).
06. DPCM Demodulator (DPCM DECODER).
07. Adequate no. of other electronic components.
08. Mains ON/OFF switch, fuse and jewel light.
* The unit is operative on 230V ±10% at 50Hz A.C. Mains.
* Adequate no. of patch cords stackable from rear both ends 4mm spring loaded plug length ½ metre.
* Good Quality, reliable terminal/sockets are provided at appropriate places on panel for connections /observation of waveforms.
*强烈支持的详细操作教诲tions, giving details of Object, Theory, Design procedures, Report Suggestions and Book References.

OTHER APPARATUS REQUIRED
* Dual Trace Cathode Ray Oscilloscope 20MHz.